Ишлэл:
Za neg asuudal shiideed ogwol shagnaltai shuu. Zowooj bna. Mashinaa parking hiicheed tsoojilchood garch ireed haalgaa ongoilgoh geheer chip n ajillahgui yum. Tegeed tulhuureer erguulj ongoilgochood haalgaa ongoilgood haahaar tog n ireed bna. Tegeed asaasnii daraa ODOmeter Trip a,b noiloltson, tsagnii tohirgoo aldagdtsan, hed idsen n noiloltson, tsonhnii auto n bas ajillahgui bgaad bxiin. bainga tegehgui haayaa. Bas haayaa mashinaa untraachaad untraah deer n darhaar buur toggui bolchino. Tulhuuree awaad haalgaa ongoilgood haahaar automataar asaad sunstei yum shig. Smart tulhuurgui. Zgr chiptei tulhuurtei. Zasuulah geed ochxoor sain meddeg hun bhgui yum. Eniig shiideed yanzlaad ogoh hun bwal Mongo tolboriig n hiieee. Help,
Hi, miniiheer bol ehleed 12V battery-g shalgah heregtei baihaa. Huitend huchdel n unaad baigaam bishuu.
1. 12V battery muudsan - solih
2. battery zalguur zugeer eseh. Yamar negen mass baij boloh yum.
Er n 12.2-oos ch yumuu doosh orj baival battery solih bolson gesen ug. Ternees bolood 12V bus-iin heseg aldaatai ajillaad ehelj boloh yum.
Mun uur tom asuudal ch baij bolno. Yamar ch l gesen dood procedure-aar neg shalgaad uz. Herev tester baival shuud uzchih.
DO-IT-YOURSELF TEST PROCEDURE:
- Without brake pedal, press the Power button once and release to enter ACC mode
- Press and hold the MFD Info button, then turn the headlights on and off three times to enter Maintenance mode; release Info button
- Press “Menu” (on screen)
- Press “Display Check”
- Press “Vehicle Signal Check” - the battery voltage is shown and should be about 12.4 to 12.8 Volts (normal for an unloaded battery)
- Again without brake pedal, press Power button and release to put a current load on the battery - the voltage should stay above 12.0V (if less than 12.0V the battery is not well, or there is a fault or unusual load somewhere)
- Press brake pedal and press Power button once to enter "Ready" mode - the battery is now charging at about 14V (if less than 13.6V or more than 14.4 there may be a problem with the charging circuit)
- Turn car OFF to leave Maintenance mode